Simplek Stick Pro Bedienungsanleitung Seite 18

2.5. Installation example Yamaha PW:
Tools needed:
• 3 mm allen key
• 6 mm allen key
• small screwdriver
Unscrew the three 3 mm allen screws (image 15). It is possible that these are provided with a screw-locking device.
In this case, heat the screws first.
Remove the two 6 mm allen screws 1 and 2 (image 16). Unscrew the third 6 mm allen screw (image 17) as far as
possible until the motor can be swung out of the frame (image 18). Now you can see the plug connections.
Disconnect the connector of the speed sensor by pressing the detent with the small screwdriver.
Now connect the motor-side connector (red and black cables) of the connection cable to the position of the
previously disconnected speed sensor. Ensure that the connectors are correctly seated (audible clicking noise when
snapping into place). Then connect the speed sensor to the second connector of the sIMPLEk connection cable (2
white cables). Then the motor can be fixed in the frame again and all screws can be installed.
Lay the USB connection cable with the supplied cable ties to the desired position of the sIMPLEk stick Pro.
image 15
image 17
image 16
image 18