Checking That The Wireless Lan Setting Is Completed - Canon i-SENSYS MF6180dw Handbuch

8
Select <Yes>, and then press [OK].
En
9
After the <Connected.> screen is displayed,
wait until the Wi-Fi indicator stops blinking and
turns on.
Wait approximately 2 minutes after the
connection.
IP address is set during this period of time.
When an error message appears:
Press [OK] to close the screen, check whether or not
the network key is correct, and then retry the settings.
If the access point cannot be detected even after
retrying, see the following.
e-Manual "Onscreen Messages"
To set IP address manually:
e-Manual "Connecting to Wireless LAN (MF6180dw
Only)"
8
Checking That the Wireless LAN Setting
is Completed
1
Press [ ] (Status Monitor/Cancel).
2
Select <Network Information>, and then press
[OK].
3
Select <IPv4>, and then press [OK].
4
Select <IP Address>, and then press [OK].
5
Take note of the IP address.
IP Address
192.168.0.215
6
Press [ ] (Status Monitor/Cancel).
7
Start a web browser from a computer, enter
"http://<IP address of the machine>/" in the
address fi eld, and then press [Enter] on your
keyboard.
8
Check that the screen of the Remote UI is
displayed.
Connection is completed if the screen is displayed.
When the screen is not displayed correctly:
e-Manual "Network Problems"