Canon WP-DC35 Benutzerhandbuch Seite 30

5
Slide the lock release switch as
shown, and release the catch to
open the case.
• When using commercially available
anticondensation products, the
anticondensation solution should only be
applied to the inside surface of the lens
window using a soft cloth. If anticondensation
solution comes in contact with any surface
other than the inside of the lens window, wipe it
off immediately with a soft, dry cloth, as it could
lead to deterioration of the Waterproof Case.
Apply a thin coat of grease to the entire seal
before using the Waterproof Case in order to
prevent abrasion and deterioration.
For waterproof seal handling precautions, see
"Waterproof Seal" on page 6.
1. Remove the waterproof seal.
2. Using a cotton swab, wipe off any debris
(e.g. sand, dirt or hair) which is present
on the waterproof seal and on the seal
mounting groove of the Waterproof
Case.
3. Apply a small amount (droplet) of grease
to your fingertip.
4. Evenly coat the entire surface of the
waterproof seal, taking care not to
scratch the surface.
5. Place the waterproof seal back in the
seal mounting groove of the Waterproof
Case.
11