2.Avoid extreme temperature change to the stone. DO NOT place frozen foods on
a hot stone.
3.The stone is fragile and can break if bumped or dropped.
4.The stone is very hot during use and stays hot for a long time after use.
5.DO NOT cool the stone with water when the stone is hot.
6.After cleaning the stone with water, please dry the stone before use. This can be
done in a conventional oven at 60°C (140°F) for 2 hours.
Problem
Burner will
not light
Sudden
drop in gas
flow or low
flame
Possible Cause
1.No gas flow.
2.Coupling nut and
regulator not fully
connected.
3.Obstruction of gas
flow.
4.Disengagement of
burner to valve.
5.Incorrect assembly.
1. Out of gas.
Prevention/Solution
1.Check to see if propane tank
is empty.
2.Turn the coupling nut about
one- half to three quarters
additional turn until solid stop.
Tighten by hand only - do not
use tools.
3.Clear burner tube.
4.Reengage burner and valve.
5.Check steps in assembly
instructions.
1.Check for gas in propane tank.
2.Turn off gas control knob, wait 30
seconds and light oven. If flames
are still low, turn off gas control
knob and propane tank valve.
Disconnect regulator. Reconnect
regulator and leak test. Turn on
propane tank valve, wait 30
seconds and then light oven.
- 15 -