Using The Oven - Vevor Gb-Go16A-R Bedienungsanleitung

spray bottle, brush or rag to apply the solution to the fittings.
TO TEST
1.Turn the burner valve OFF.
2.Turn the liquid propane cylinder valve on counterclockwise to open the valve.
3.Apply the soap solution to all gas fittings. Soap bubbles would appear where a
leak is present.
4.If a leak is present, immediately turn the gas supply OFF and tighten leaky
fittings.
5.Turn the gas back ON and recheck.
6.Should the gas continue to leak from any of the fittings, turn the gas supply OFF
and contact customer service.
OPERATING INSTRUCTIONS

USING THE OVEN

Each burner is rated at 19 0 0 0 BTU/Hr.
To begin:
1.Make sure the oven has been leak tested and properly placed.
2.Remove any remaining packing material.
3.Light the burner using the LIGHTING INSTRUCTIONS below.
LIGHTING INSTRUCTION
TO LIGHT THE BURNER
1.Make sure the control knob is in OFF position, and then turn the liquid propane
cylinder valve ON by slowly turning counterclockwise.
2.Push in and slowly turn the control knob anticlockwise until you hear a click and
the burner ignites.
3.If burner doesn't light, turn the knob OFF, wait 5 minutes and repeat the lighting .
- 13 -