Cleaning, Maintenance And Ordering Of Spare Parts - Einhell Tc-Ld 30 R Originalbetriebsanleitung

•
Front edge reference point (see Fig. 4)
•
Rear edge reference point (see Fig. 4)
6.4 Using the measurement functions
Note:
The laser beam switches off automatically after
completion of each measurement. Press the ON/
Measuring button.
6.4.1 Function: "Measure single distance"
"No symbol" (Fig. 5)
Procedure:
•
Press button A once:
Switch on the equipment
•
Press button B for longer if necessary:
Select the reference point on the equipment
•
Press button A once: Switch on the laser
•
Align the laser
•
Press button A once: Measure
→ The result is displayed at the bottom in m
6.4.2 Function: "Measure areas"
"Symbol " (Fig. 6)
Procedure:
•
Press button A once:
Switch on the equipment
•
Press button B once: Select function
•
Press button B for longer if necessary:
•
Select the reference point on the equipment
•
Press button A once: Switch on the laser
•
Align the laser
•
Press button A once: Measure the area length
•
Press button A once: Switch on the laser
•
Align the laser
•
Press button A once: Measure the area width
→ The result is displayed at the bottom in m²
6.4.3 Function: "Measure volume"
"Symbol " (Fig. 7)
Procedure:
•
Press button A once:
Switch on the equipment
•
Press button B twice: Select function
•
Press button B for longer if necessary:
Select the reference point on the equipment
•
Press button A once: Switch on the laser
•
Align the laser
•
Press button A once: Measure the room
length
Anl_TC_LD_30_R_SPK13.indb 12 Anl_TC_LD_30_R_SPK13.indb 12
GB
•
Press button A once: Switch on the laser
•
Align the laser
•
Press button A once: Measure the room width
•
Press button A once: Switch on the laser
•
Align the laser
•
Press button A once: Measure the room
height
→ The result is displayed at the bottom in m³
6.4.4 Function: "Measure continuous dis-
tance (min/max)"
"Symbol " (Fig. 8 / 8a / 8b)
Procedure:
•
Press button A once: Switch on the equip-
ment
•
Press button B three times: Select function
•
Press button B for longer if necessary: Select
reference point
→ The highest measurement result so far is
displayed at the top in m
→ The lowest measurement result so far is
displayed in the center in m.
→ The current measurement result is dis-
played at the bottom in real time
7. Cleaning, maintenance and
ordering of spare parts
Danger!
Always pull out the mains power plug before star-
ting any cleaning work.
7.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it with compressed air at low
pressure.
•
We recommend that you clean the device
immediately each time you have finished
using it.
•
Clean the equipment regularly with a moist
cloth and some soft soap. Do not use
cleaning agents or solvents; these could at-
tack the plastic parts of the equipment. Ensu-
re that no water can seep into the device. The
ingress of water into an electric tool increases
the risk of an electric shock.
7.2 Maintenance
There are no parts inside the equipment which
require additional maintenance.
- 12 -
12.03.2025 08:47:51 12.03.2025 08:47:51