Werbung
Verfügbare Sprachen
Verfügbare Sprachen
!
Please note: The locking barrel can be used for shallow or deep insertion to suit handlebar diameter (simply
invert as required).
!
If the rubber ring supplied is too thick for your handlebar, please contact our service team. (Mail: service@
bumm.de, Tel.: +49 2354 915-7111) We will send you a thinner rubber ring free of charge.
!
Insert the headlight
into the upper plate of the headlight bracket
1
tion of travel) and firmly push it into place until it audibly engages. Be sure to check that it is securely seated.
To remove the headlight
1
, press the release button on the bracket
1
in the direction of travel), while firmly holding the headlight
for any damage caused by disconnection and drop-falling, e.g. because the headlight
while it was removed.
Adjustment:
Vertically: The headlight
1
can be adjusted vertically (e.g to adjust for handlebar angle) by tilting around the
rubber ring.
Horizontally: The headlight
1
can be swivelled (to a limited extent) to the left or right on the rubber ring (eg.
to centre beam on the roadway).
In both cases, the locking screw of the bracket must be loosened and after adjustment re-tightened.
32
from the left (looking in the direc-
2
2
(located to the right of the headlight
1
and pull it off to the left. We exclude liability
1
was not held tight
6.4. Suspended mounting IXON Core 2
Should assembly with the standard handlebar bracket not be preffered, a suspended mount for the
headlight
1
be used. This can be mounted under the handlebar to suit the bicycle cockpit situation
(but not inverted) by using one of a number of other B+M brackets instead of the one supplied.
One that is often used is:
481GPPB for Assembly on e.g GoPro, Garmin or selected Wahoo-Adapter.
For further bracket options please consult our spare parts shop: www.bumm-shop.de.
33
Werbung
