Werbung
Verfügbare Sprachen
Verfügbare Sprachen
6.2. Headlight alignment
WARNING
Do not use the bicycle if the light beam of your headlight
the headlight
1
is too loose. Blinding oncoming traffic can cause accidents. Before aligning the bicycle head-
light
1
, loosen the bracket retaining screw first. Make sure to retighten this screw again afterwards.
WARNING
Never adjust the light range of your headlight
and injuries.
WARNING
Never look directly into the light of the bicycle headlight
Attention: Ensure a non-blinding orientation of the beam pattern
Image: correct beam orientation with light switched on
30
is misaligned or
1
1
while cycling! This may result in serious falls
when switched on.
1
Beam cut line
6.3. Mounting instructions IXON Core 2
Place the rubber ring provided around the handlebar. Select the locking screw to fit the handlebar
diameter and push it into the suitable end of the locking barrel (also according to Handlebar diameter).
Insert the attachment cylinder into the bracket axle and screw the remaining open end of the locking
screw into the thread of the cylinder. Place the handlebar bracket over the rubber ring on the handlebar
with the locking barrel facing the saddle. Position the legs of the bracket
screw the barrel into the retaining hollow on the rear leg. Tighten until a secure clamping is attained.
Short screw (30 mm)
Kurze Schraube (30 mm)
Kurze Schraube (30 mm)
Long screw (55 mm)
Lange Schraube (55 mm)
Lange Schraube (55 mm)
around the rubber ring and
2
31
Werbung
