MPM MOD-60 Bedienungsanleitung Seite 17

TROUBLESHOOTING
Problem:
Dust canister cannot be placed in their
seat.
Vacuum cleaner canister overheating.
Low suction power.
TECHNICAL DATA
Technical parameters are indicated on the product rating label.
Length of power cord: 4,5 m
Reach of vacuum cleaner: 7,5 m
Note! MPM agd S.A. reserves its right to modify the technical data.
PROPER DISPOSAL OF THE PRODUCT
Poland Marking on the product indicates that after the service-life of the product expires, it should not be disposed
with other type of municipal waste. Used equipment may have a negative impact on the environment
and health of people due to potentially containing hazardous substances, mixtures and components. Mixing
electric waste with other types of waste or disassembling those in an unprofessional manner may cause
a release of substances that are hazardous to the environment and health. Used equipment should be handed-over to
a point for collection of electric waste. In order to obtain detailed information regarding the electric waste collection points,
the user should contact the municipal point of electric waste collection or used equipment processing department.
Possible causes:
The filters were not properly installed.
A slight increase in the temperature of the vacuum cleaner canister is normal. If the
temperature is rising considerably, immediately turn off the vacuum cleaner and wait
until cools.
The air filters are very dirty.
The dust canister is full.
The suction hose and/or the telescopic
wand is clogged.
(waste electrical and electronic equipment)
Solution:
Install the filters properly.
Clean or replace the filters.
Empty the dust canister.
Unclog the suction hose and/or the
telescopic wand.
17