MPM MOD-60 Bedienungsanleitung Seite 15

SMALL BRUSH
Intended for cleaning flat surfaces, furniture, upholstery, and mattresses. The compact sizes
make it perfect for cleaning hard to reach places and whenever the floor and carpet tool is
too big.
CREVICE TOOL
Used for cleaning difficult to access areas, such as in room corners, by and below pieces of
furniture and in bends and slits. It is also perfect for cleaning computer keyboards, drawers,
radiators or window frames.
EMPTYING THE DUST CANISTER
To empty the dust container ⑤, switch off the vacuum cleaner,
disconnect it from the power supply, unhook the suction hose
⑮ by making half a turn and finally press the button ④ and
pull out the dust container from the appliance. Place the bin
over the rubbish dumpster, release the lid button ⑦ as shown
in Fig.1 and dump the dust into the bin. After emptying the bin,
close the bottom lid and put the container back into its place in
the vacuum cleaner - a characteristic click can be heard when
the container locks into the appliance.
AIR FILTER CLEANING AND REPLACEMENT
Normal operation of the vacuum cleaner requires cleaning the main filter ⑨ each time after it
is emptied. Clean the exhaust filter ⑫ at least every few times the dust container is emptied.
Replace filters with new ones on regular manner. Unplug the vacuum cleaner from the power
supply and disconnect the suction hose before cleaning.
1. The main filter ⑨ is located in the dust container and consists of a protective grid and a basic
filter. Remove the dust container from the vacuum cleaner, take off the lid of the container
(Fig.2), take out the main filter (Fig.3) and the protective grid (Fig.4). The filter and the grid can
be gently cleaned with a soft brush (Fig.5) and rinsed under running water (Fig.6). Remember
to let the filter and protective grid dry completely before putting all parts back together.
Follow the markings on the individual components when dismantling and assembling any
parts of the appliance.
Fig. 1
15