TROUBLESHOOTING
No Power on
Fault connection
tightly connected to the inverter and the power source
Battery voltage below 10V
Equipment being operated draws too much power
cool down. Ensure there's adequate ventilation around the inverter. Ensure
that load is no more than it's maximum rating for continuous operation
Low Voltage alarm turns on immediately
The input voltage at input of the Inverter needs to be raised
Recharge/Replace battery or add additional batteries. Run the vehicle engine
when using a 12V DC plug
Low voltage arm is on all the time
Power battery condition with voltage drops
Inadequate power or voltage drops
and cable leads. Clean or replace as necessary
Low power output
Battery condition may be poor
Fault connection
Inverter does not work after connecting the cables in reverse
The internal protection has disabled the inverter
company for help
Enjoy your product * Share your experience and opinion on one of the
Turn the inverter's power switch off; Verify cable are
Recharge or replace battery
Recharge or replace a battery
Make sure the battery and Inverter terminal are clean
well-known internet portals
Allow the inverter to
Replace battery
Check condition of battery cables
Contact vendor