Technaxx TE16 Gebrauchsanleitung Seite 19

Overload Protection (Red LED on Inverter)
The Inverter will automatically shut down if the continuous draw exceeds its
maximum wattage rating. When the Inverter is at or near maximum output, an
alarm will sound. When the alarm sounds you need to disconnect the device(s)
to bring the Inverter output down to an acceptable level.
If you continue to use the Inverter at or near the maximum output, it will
eventually overheat and shut down. If you exceed the maximum Inverter
output, the alarm will sound and the Inverter will automatically shut down. The
red fault indicator will light and the alarm will continue to sound. The Inverter
must be reset after an overload condition.
Temperature protection
The Inverter is equipped with a cooling fan. Depending upon the load output
and the temperature of the Inverter, the cooling fan will turn on and off as
required to cool the Inverter if needed. If the temperature reaches
approximately 80°C the Inverter will shut down automatically. Turn off the
Inverter and allow it to cool for a minimum of 15 minutes. Before starting up
again, verify the total wattage of the devices being powered.
To reset the inverter
1. Turn off the Inverter using the ON/OFF switch on the Inverter, depending
upon how the Inverter was controlled.
2. Unplug all devices.
3. Turn the Inverter back on using the ON/OFF switch on the Inverter. Before
devices are reconnected, verify the total wattage of the devices to ensure they
are less than the rating of the Inverter.