Eco Mode (Temporary Reduction In Temperature Down To 30 °C) - Berner Bio Bedienungsanleitung

4.4 ECO MODE (TEMPORARY REDUCTION IN TEMPERATURE DOWN TO 30 °C)
ECO mode enables the temperature of the bath to be reduced for reducing electricity consumption for 11 h* Beyond
this time, the temperature will return to its normal operating level.
HEATING light OFF.
ECO light flashing slowly
* time adjustable – see paragraph 7.2
4.5 SOAKING
- Carry out tests for validating the cleaning protocol (compatibility of materials, soaking time, etc.), espe
cially for sensitive metals such as zinc, brass and aluminium alloys (including those containing silicon).
- Never leave a part to soak over-night.
-Limit soaking time to a minimum.
SOAKING OPERATION
1. Close the tank drain by placing the plug in position with one of its lugs opposite the hollow used for raising the
plate.
2. Close the soak-tank with the rectangular cover.
3. Put the part in the tank.
4. Press the pump control button to fill the tank and leave it in operation so that the
solution is maintained at the right level for soaking.
5. Open the tap of the semi-rigid hose.
CAUTION
- Check that there is no residue (chips, sand, etc.) in the area where the plug is to be placed. Clean with
the brush if necessary.
- Make sure that there is nothing blocking the overflow opening.
- The plug with the four lugs is designed to provide a liquid flow that is sufficient for the solution to be renewed, and
kept at the right temperature and for the soak-tank to empty when the pump is stopped.
- For soaking, the plug must be positioned the right side up.
The tempera-
ture drops down
to a minimum of
30 °C
Temperature attained ->
The same temperature is
maintained for 11 hours*
T° = 30°
8
(EN)
T° = 38°
Temperature rises to
38°C
Green light flashing, then green
light flashing slowly when the
temperature of 38 °C has been
attained.