Berner BIO Bedienungsanleitung Seite 10

BOOST
B
U
T
ECO
T
O
N
HEATING
S
7 VIEWING & MODIFYING PARAMETERS
7.1 PARAMETER-VIEWING MODE
Control
E
N
T
R
Y
E
V
E
N
T
S
BOOST ON/OFF (Increases the HEATING temperature by 5 °C
above the nominal operating temperature).
- ECO ON/OFF (Lowers the temperature down as far as 30 °C).
- Reduces the value of the parameter (parameter setting mode)
- HEATING ON/OFF
- Validates the parameter
- Safeguards the parameter
- Exits the parameter-setting mode (Press for over 2seconds)
To enter the parameter-viewing mode, press sharply
on the 2 BOOST and ECO buttons at the same time.
The bath temperature and the length of operation in
ECO mode will be displayed.
The "EVENTS" message will appear by pressing the
°C –ON/OFF button
Press the button for viewing the events that have
been memorized.
- If no events have occurred over the last 48 hours, a
"No error" message will be displayed.
- If an event has occurred over the last 48 hours, the
first event will be displayed.
By pressing the button a second time, the time
since the event will be displayed.
By pressing the button a third time, the next event
will be displayed.
10
(EN)
Message on display
screen
V 4.5 37°C
ECO TIME 18H
V 4.5 37°C
EVENTS
V 4.5 37°C
No Error
V 4.5 37°C
ADD PRODUCT
V 4.5 37°C
01:35:20