Berner BIO Bedienungsanleitung Seite 16

APPENDIX 2: REMOVING AND REFITTING THE ELECTRIC KIT
Tools required: None
CAUTION
- Unplug the parts washer before the operation.
- Warning: Electric connector of the pump to never be in contact with the liquid into the tank.
REMOVING
1 Lift up the sink, unclip
the black hose under the
semi-rigid hose.
2 Remove the brush hose
from its indentation and
remove the sink
3 Disconnect the pump hose
and electric cable.
4 Disconnect the pump
electric cable.
5 Take off the pump.
6 Slide up the electric kit to
take it off.
REFITTING (see § 2.2)
1 Fit the electric kit in its
adapted slide / compartment.
2 Deposit the pump on the
bottom of the tank
3 Connect the pump electric
cable to the kit
4 Connect the pump to the
filter entry hose..
5 Place the power cord in
the adapted groove until the
bottom of the sink.
6 Clip the black hose under
the sink
7 Place back the brush hose
in its indentation.
8 Position the sink to its
standard position.
16
(EN)