General Information - Berner Bio Bedienungsanleitung

(EN)

1.3 GENERAL INFORMATION

The parts washer meets all safety requirements stipulated in the following directives:
- Machines directive 2006/42/CE;
- Low voltage directive 2014/35/EU;
The manufacturer confirms that the device is in
conformity with the 2006/45/CE directives under
provided that no modification is made on this device.
For assistance, please contact your commercial
agent and with every request specify the serial num-
ber glued to the back of the machine:
1.4 HANDLING / TRANSPORTING / MOVING THE
PARTS WASHER
- For moving or transporting the parts washer, drain it into empty cleaning solution cans (See section 5).
- Place the parts washer vertically on a 1200 x 800 mm palette (The parts washer should never be transported lying
flat).
- Protect the parts washer with an appropriate packaging.
- Film the palette to prevent it from tipping over during transport.
1.5 CHARACTERISTICS
Maximum power
Noise level
Weight when empty (without cleaning solution)
Tank material
Power supply
Nominal operating temperature
Overall dimensions
Usable cleaning tank dimensions
Filtration
Tank Capacity
Soaking area Capacity
Minimum level without soaking
Minimum level with soaking
Tool-holder flow (brush alone)
1050 watts.
< 50 dBa.
46 Kg
Medium density polyethylene (PEMD).
230 V + T Ground, protected by a 30mA fault circuit breaker
38°C
905 x 650mm - h: 1080mm (lid closed).
790 x 420 x 200 mm
SS basket filter 700µ / external SS filter 140µ
55 to 100 liters
30 liters. Soaking height 90 mm.
55 liters in the tank.
87 liters (55 liters in the tank + 30 liters in the soak-tank + 2
liters of product in the piping).
3.4 liters / mn (with clean filter)
3