Berner BIO Bedienungsanleitung Seite 7

(EN)
4 START-UP
4.1 SWITCHING ON
After the parts washer has been filled with cleaning solution, switch on the Part Washer.
Then, push the HEATING button until the operating temperature has been reached.
Push the heating
button
4.2 USING THE PARTS WASHER
Press the pump control button, then clean your parts with the tool-holder and brush.
A clip is provided to make it easier to guide the tool-holder hose.
CAUTION
This clip is not designed for attaching the tool-holder!
4.3 BOOST MODE (TEMPORARY TEMPERATURE INCREASE OF 5 °C)
The higher temperature is to be used when severely fouled parts need to be cleaned.
BOOST light flashing.
HEATING light ON.
White light ''On''.
Green light is flashing.
25 mn
Temperatures attained ->
heating off.
BOOST light ON.
HEATING light ON.
T°
2h00
T° = 43°
7
T° = OK
Green light flashing slowly
Toolholder
hose clip
T° = 38°
Green light flashing when the
temperature returns to 38 °C.