Vulkan LOKPREP LDS-SET-H Betriebsanleitung Seite 7

5.2.4
Set the adjustment screw at the top of the
dispensing valve (16) to "3".
5.2.5
Make sure that the LOKPREP and air hoses
of the dispensing valve handle (15) protrude
from the holes of the handle and allow
connection to the fittings at the dispensing
valve (16).
5.2.6
Open the clamping screw of the dispensing
valve handle (15) using a screwdriver
Torx 15 and slide in the upper part of the
dispensing valve (16) until the stop. Rotate it
into the desired position (suitable to connect
the hoses) and tighten the clamping screw.
You might loosen the screw after the next
step if it makes the hose connection more
convenient but make sure to tighten it again
after that. Check the appropriate length of
the hoses (LOKPREP and air) for proper
connection and cut them accordingly if
necessary.
5.2.7
Insert the 4 mm air hose into the 90° elbow
air inlet (18) up to the stop.
LDS-SET-UM-U1-V1.0
16
18
Operating Instructions / LOKPREP® Dispensing System LDS-SET-H / LDS-SET-V
16
15
15
EN
DE
7