Cartridge Sleeve Stand - Vulkan Lokprep Lds-Set-H Betriebsanleitung

5.5.4
Adjust the filter pressure regulator (4) to a
pressure of 5 bar for proper function of the
dispensing valve (16).
5.5.5
Insert the device connector of the 6 mm air
hose (8) from the reservoir to the socket
named "RESERVOIR" at the rear side of the
dispensing valve controller (1).
5.5.6
Connect the dispensing valve controller (1)
to an electric power supply using the power
cable (2).
Power supply: 85 to 264 V AC 50/60 Hz
5.6

Cartridge sleeve stand

5.6.1
Use a 10 mm allen key to assemble the
screw to the cartridge sleeve stand. Counter
the nut using a 19 mm open-end wrench.
LDS-SET-UM-U1-V1.0
4
1
1
Operating Instructions / LOKPREP® Dispensing System LDS-SET-H / LDS-SET-V
EN
DE
8
2
13