Dispensing Valve Controller - Vulkan Lokprep Lds-Set-H Betriebsanleitung

5.4.5
Connect the inlet of the filter pressure
regulator (4) to a pressurized air supply
of at least 5 bar (72.5 psi) but max. 7 bar
(101.5 psi). The inlet of the filter pressure
regulator (4) is marked with "1". If suitable
you might want to use the hose with brass
plug (7). The plug fits most quick connectors
of pressurized air supply systems. If
necessary, please adapt from your individual
supply socket to a 6 mm air hose which can
be pushed into the inlet side of the filter
pressure regulator (4).
EN
5.5

Dispensing valve controller

DE
5.5.1
Insert the device connector of the 4 mm
hose from the dispensing valve handle (15)
to the socket named "VALVE" at the rear side
of the dispensing valve controller (1).
5.5.2
Insert the white 2 pin electric connector
coming from the dispensing valve handle
(15) to the socket named "FOOT SWITCH"
at the rear side of the dispensing valve
controller (1).
5.5.3
Connect the "AIR INLET" of the dispensing
valve controller (1) with the outlet of the
filter pressure regulator (4) by using a
standard 6 mm air hose (3*) of appropriate
length (not supplied). The outlet of the filter
pressure regulator (4) is marked with "2".
12 Operating Instructions / LOKPREP® Dispensing System LDS-SET-H / LDS-SET-V
4
7
1
1
4
3
15
15
1
LDS-SET-UM-U1-V1.0