Setting Of The End Positions; Automatic Setup-Mode For Sel Plus-R And Ses-R - Selve Se Plus-R Einstellanleitung

All manuals and user guides at all-guides.com

Setting of the end positions

4.4.1. Automatic setup-mode for SEL Plus-R and SES-R

in operation: bottom position, top stop/release
When the movement is interrupted twice during operation, the system is in automatic
setup-mode. Drive types SEL Plus-R and SES-R will automatically find their stop
positions. For this, a drive must first move against the upper stop and then downwards
until it switches off automatically.
Important!
Only connect that radio drive to power that is to be programmed! You cannot program
more than one drive at the same time.
Setting with
transmitter
or
Auto-Stop top and bottom,
keep motion button pressed
PROG
1 sec.
Setting with
setting
Drive
switch movement
PROG
1 sec.
31
1. Connect to power.
2. For setting with transmitter: press the UP
and DOWN buttons at the transmitter at
the same time. The transmitter is tempo-
rarily taught into the drive.
3. Move the drive upwards with the UP or
DOWN button. The correct rotation direc-
tion assignment will be performed at the
end of the end position setting.
4. The drive moves against the upper stop
and stops automatically.
5. Continue to keep the button pressed or
press one of the motion buttons again.
Now the drive automatically moves
down wards.
6. The drive will reach the lower limit and
stop automatically.
7. The end positions are now set and the
rotation direction assignment is correct.
Perform a test run.
8. For setting with transmitter: press the
PROG button at the transmitter.
When setting with setting cable: press the
UP and DOWN buttons on the trans-
mitter at the same time, and then the
PROG button.
9. The transmitter is now permanently
taught-in.
GB