Maintenance Instructions - Bestway Rio Od161786 Gebrauchsanweisung

GB
Inflation Instructions:
Inflate the top ring carefully; it is recommended to use low pressure electrical pump or hand pump to inflate the top ring.
When the top ring reaches the correct pressure, it should be slightly stiff to the touch. Over-inflating the top ring can cause
permanent deformation or damages, due to the high elasticity of the PVC material.
To increase the lifespan of the top ring, we recommend to add air as few times as possible during the season. If the top ring
becomes soft, wait until sunset to re-inflate until it is slightly stiff to the touch.
Helpful Installation Tips:
We strongly suggest opening the package and assembling the pool when the ambient temperature is above 15°C / 59°F. The
PVC material of the liner will be more flexible and easier to assemble in this environment.
We suggest you buy a pool ladder (if one is not included in the set) and prepare it before setting up the pool, as it will help
whenever you need to get inside it.
Step 2: When the pool is filled with around 0.01 m of water, gently smooth out the bottom liner to remove all folds. We
recommend starting from the center of the pool and continuing outwards. You can continue to fill the pool when the floor is
smooth and wrinkle-free.
Filling the Pool with Water:
ATTENTION: Do not leave the pool unattended while filling with water. Continuously check the pool to ensure it is being
filled correctly.
It is highly recommended to use tap water for filling to minimize unwanted content, such as minerals. Do not use sea water.
Fill the pool with water after all assembly steps are completed. The pool is full when the water reaches the welding line
(under the inflated top ring as shown in Step 5).
IMPORTANT: When reaching the proper water level, check that the distance between the water surface and the top ring is the
same all around. If it is different, it means that the surface is not level, and we strongly recommend draining the water and
adjusting the chosen location. Never attempt to move the pool with water still in it.
IMPORTANT: Keeping the pool full of water on unlevel ground can cause the bursting of welding points and/or pool collapse,
causing serious personal injury and/or damage to property. Do not overfill as this could cause the pool to collapse. In the case
of heavy rainfall, we strongly recommend reducing the water level to keep the proper water level and avoid the overflow of
water. Do not add any chemicals to the water until the set up is complete.

MAINTENANCE INSTRUCTIONS

Keeping your pool water clean and chemically balanced is necessary. Simply using the filtration system and cleaning the filter
cartridge is not enough for proper maintenance of the water.
It is important to prioritize the maintenance and health of your pool water. If you do not adhere to these guidelines, your and
your family's health might be at risk.
Water Maintenance:
We recommend you use pool chemicals to maintain water chemistry and chlorine or bromine tablets (do not use granules)
with a chemical dispenser.
The chemical maintenance with chemical tablets must be performed with a chemical dispenser or chemical floater. Do not
throw chemical products directly into the water. The chemicals will settle on the bottom of the pool and damage and discolor
the liner. In the worst cases, it will damage the structure of the pool liner.
Pool damage resulting from the misuse, number of users and overall mismanagement of pool water is not covered by
the warranty.
Water quality is directly related to frequency of use, number of users and overall maintenance of the pool. The water should
be changed every 3 days if there is no chemical treatment being performed with the water. We recommend that you take a
shower before using your pool, as cosmetic products, lotions and other residues on the skin can quickly degrade water
quality. Place a bucket of water next to the pool to clean users' feet before they enter the water.
Chemical Usage:
We recommend maintaining your water's chemical balance as shown in the table below.
Exceeding the following parameters can damage the structure of the liner and create a dangerous situation for the users.
40