eta LEONE Bedienungsanleitung Seite 44

EN
5.2 BATTERY CHARGING
1. Check that the charging station is properly connected to the mains.
2. Place robot vacuum near the charging dock, press button C2/G7 and wait until the robot
vacuum has correctly approached to the charging contacts. If the battery is too low,
place the device close to the charging contacts.
• Standard charging time is approx. 4-5 hours. Fully charged battery will work for
approx. 235 minutes, depending on set functions.
• The stated operating times are based on ETA's internal testing and only apply to
a new and fully charged battery. Depending on the age and wear of the battery, the
operating time decreases.
• After cleaning, the device will find the base automatically.
• The level of battery charging can be easily determined using "ETA SMART" app. You
can also sent the device back to the base using this app.
5.3 SWITCHING ON / STANDBY MODE / SLEEPING MODE / AUTOMATIC SWITCHING
OFF / CHILD LOCK
Start (Cleaning)
Press C1/C3/G3/G8 to switch on the robot vacuum.
Standby mode (Pause)
After switching on, the robot vacuum always goes to standby mode. If the vacuum robot is
in operation mode (i. e. cleaning is being carried out), it can be switched to standby mode
by pressing C1/C2/C3/G3/G8.
The device must go out from the charging dock for the cleaning. Place the charging
dock appropriately, according to the instructions above, and do not change its
location to allow the device to return back to the charging dock after cleaning.
Sleep mode / automatic switching off
If the robot vacuum will stop in the room, it will be automatically switched to sleep mode
after 10 minutes of inactivity. After following approx. 4 hours (in sleep mode), it will be
switched off automatically. Then the robot vacuum must be switched on again by long
pressing button C1 (approx. 3 seconds).
Factory setting of the voice message is Czech.
≈
4-5H
Notes
Notes
EN - 44
Note