Therabody JetBoots PRO Plus Benutzerhandbuch Seite 5

4. Use the Device
1. Put on your boots. It is recommended that you wear shorts while using the device to allow the device to contact your skin directly. Reach a comfortable position, either sitting upright or lying down with your legs straight and feet elevated. Unzip the boots completely and
place each leg and foot inside each boot. Your legs should be in the center of each boot; keep them in between the infrared LED lights as a reference point. Your feet should be as close to the bottom console as possible.
2. Zip up the boots and keep them flat. Keep your legs straight and flat to prevent kinks and folds. Only hold the boots' edges when handling them. Avoid holding the device from the internal layer. Zip both boots up.
**Do not use the device while standing or walking. Only use the device while the zippers are fully zipped closed. Do not unzip the device while in use.
3. Turn on the device. To turn on your device, press and hold the center button on the control panel of the lead boot. The LCD screen on the control panel will light up when the lead boot is on. Press and hold the button on the support boot to power it on. The button will
illuminate when the support boot is powered on. Each boot will vibrate as it powers on. The boots will connect to each other via low power Bluetooth once they are both powered on.. Once connected, a two-boot and battery icon will display on the LCD screen.
1
Figure 3. How to position oneself in the boots
2 3 4
EN
5