Optional Accessories; Exploded Drawing And Spare Parts List - Mafell Rf 34-18 Originalbetriebsanleitung

Defect
Sudden smoke emission from the
motor casing
Machine stops.
Milling cutter jams as the machine
is advanced.
Burn marks on the milled
surfaces.
Chip ejection blocked
9

Optional accessories

- HM indexable cutting insert (6 pieces)
- Rechargeable battery PowerTank 18 M 72 LiHD
- Rechargeable battery PowerTank 18 M 72 LiHDX
- Rechargeable battery PowerTank 18 M 99 LiHD
- Rechargeable battery PowerTank 18 M 144 LiHD
- Rechargeable battery PowerTank 18 M 144 LiHDX

10 Exploded drawing and spare parts list

The corresponding information in respect of spare parts can be found on our homepage: www.mafell.com
Cause
Overload of the
electronic system
When the machine is overloaded,
the restart protection is triggered.
Blunt milling cutter
The milling cutter is unsuitable for
the operation or blunt.
Wood is too damp
Extended milling
extraction
-29-
Elimination
machine's Interrupt the power supply by
removing the battery pack. The
smoke emission stops.
Do not insert a rechargeable
battery! Avoid inhaling the
smoke!
Switch machine off and on again
Switch
immediately.
Remove the machine from the
workpiece and replace the milling
cutter.
Replace the indexable cutting
inserts.
Replace the indexable cutting
inserts.
Replace the milling cutter
Clean chip ejection
Use dry wood
without Connect machine to an external
extraction system
off the machine
Order No. 212682
Order No. 094500
Order No. 094523
Order No. 094503
Order No. 094498
Order No. 094520