Removing The Rechargeable Battery; Setting The Digging Depth; Milling Width; Changing The Cutter - Mafell Rf 34-18 Originalbetriebsanleitung

Inserting: Slide the charged rechargeable battery into
the battery guide below the handle until it perceptibly
engages.
Before using the machine,
convince yourself that the
rechargeable batteries are firmly
seated in the machine.

5.5 Removing the rechargeable battery

Press the battery release button 14 and pull the battery
6 out of the battery guide (see Fig. 5).
Fig. 5
Do not use force to do so.

5.6 Setting the digging depth

Danger
Unplug the rechargeable battery for
all service work.
Danger
Risk of injury from the cutter!
The are three milling depth settings (6, 8 or 10 mm /
0.24, 0.31, or 0.39 inches). Loosen the Allen screw
with the supplied SW4 Allen key and move the base
plate to the desired milling depth (see Fig. 6). Then
retighten the Allen screw.
Fig. 6
If the base plate is retracted all the
way, the maximum milling depth of
10 mm (0.39 inches) is reached.

5.7 Milling width

The milling width is 34 mm (1.34 inches). If the gutter
supports are wider than 34 mm (1.34 inches), mill a
second time, offset from the previous milling.

5.8 Changing the cutter

Danger
Unplug the rechargeable battery for
all service work.
Danger
Risk of injury from the cutter!
So as to guarantee its function, the machine is
harmonised with the milling cutter included in the
delivery, therefore only a corresponding spare part can
be used.
• Unscrew the five screws on the cover and remove
the cover along with the screws.
• Press and hold the spindle lock button.
• Turn the milling head counterclockwise until it is
loosened and can be removed.
• Replace the milling cutter and tighten it with an
appropriate wrench SW19 (13 Nm). Ensure there
are no chips on the clamping surfaces.
Deresinification is carried out by soaking the cutters for
24 hours in paraffin or commercially available resin
remover.
-25-