Safety Instructions - Mafell Rf 34-18 Originalbetriebsanleitung

3

Safety instructions

Danger
Always observe the following safety
instructions and the safety
regulations applicable in the
respective country of use!
Please also read the safety
information in the enclosed folder
070500 "Safety instructions"
(according to standard 62841-1).
General instructions:
- Only hold the power tool by the insulated
gripping surfaces when carrying out work
during which the bit may hit concealed power
lines. Cutting accessory contacting a "live" wire
may make exposed metal parts of the power tool
"live" and could give the operator an electric shock.
- Use clamps or another practical way to secure
and support the workpiece to a stable platform.
Holding the workpiece by your hand or against the
body leaves it unstable and may lead to loss of
control.
- Pay attention that other persons keep a safe
distance from your working range. Everyone
entering the working range must wear personal
protective equipment. Fragments of the workpiece
or broken insertion tools can be flung around and
cause injuries even outside the direct working
range.
- Never work without the protection devices stipulated
for the respective operating sequence and do not
effect any modifications on the machine that could
impair safety.
- Children and adolescents must not operate this
machine. This rule does not apply to young persons
receiving training and being supervised by an
expert.
- First switch on the machine and then start
machining the workpiece.
- Do not put down the machine before the tool has
coasted to a standstill.
- Protect the machine and the rechargeable batteries
from humidity!
- Do not throw the rechargeable batteries into a fire!
- Do not use any defective or deformed rechargeable
batteries!
- Do not open the rechargeable batteries!
- Do not touch the contacts of the rechargeable
batteries and do not short-circuit them!
- A slightly acidic, combustible liquid may leak from
defective li-ion rechargeable batteries! If any battery
liquid is leaking and comes in contact with the skin,
immediately rinse with a copious amount of water. If
any battery liquid gets into your eyes, rinse with
clean water and immediately consult a doctor for
medical treatment!
- Remove the rechargeable batteries from the
machine before carrying out any setting, retooling,
maintenance or cleaning tasks.
- Ensure that the machine is switched off when you
push in the rechargeable battery.
- Please remove the rechargeable battery from the
machine if the machine is put down, transported or
stored unattended.
Instructions on the use of personal protective
equipment:
- Always wear ear protectors during work.
- Always wear protective goggles during work.
- Always where a dust mark during work.
- Always wear protective gloves and a work apron
when working.
Instructions on operation:
- Keep your hands away from the cutting range and
the tool. Grip the auxiliary handle with your other
hand.
- Never support the workpiece in your hand or over
your leg. Secure the workpiece against a sturdy
support, e.g. by means of clamps.
- Never use damaged or incorrect tool washers or
screws.
- Hold the machine with both hands and bring your
arms into a position where you are able to resist the
backlash forces.
- Examine the workpiece for foreign objects. Do not
saw or mill into steel parts.
- Always mill in counter direction.
- Before starting up, check the tight seat of the milling
cutter and its correct running.
- Only use milling cutters approved for manual feed.
Only use the tool included in the delivery or a
corresponding spare part.
-22-