Changing The Indexable Cutting Insert; Chip Ejection; Operation; General - Mafell Rf 34-18 Originalbetriebsanleitung

5.9 Changing the indexable cutting insert

Danger
Unplug the rechargeable battery for
all service work.
Danger
Indexable cutting inserts are cutting
tools and have sharp corners and
sharp edges. Handle these
indexable cutting inserts with care
to prevent injuries and damage to
the inserts.
The milling head is equipped with 6 HM carbide
indexable cutting inserts. When the cutting edges
become blunt, you can turn the indexable cutting insert
up to four times. After that, new original indexable
cutting inserts must be fitted!
Follow the procedure below:
• Unscrew the countersunk screws using the supplied
SW4 Allen key.
• Clean all parts and the cutter chambers of the
milling head.
• Turn or replace the indexable cutting inserts.
• Fasten the indexable cutting inserts with the
countersunk screws and tighten them using the
SW4 Allen key (4 Nm).
The parts have been inserted correctly if the rear of a
cutter edge is resting against the carrier body, and the
countersunk screw can be screwed in that far that the
surface of the countersunk screw is located below or
on the same level as the surface of the indexable
cutting insert. The radial blade protrusion of max. 1.1
mm is thus guaranteed.

5.10 Chip ejection

Danger
Only work in adequately ventilated
rooms or outdoors. Dust can be
hazardous to health.
The chip ejector is used to eject the wood chips
created during operation. Wear a dust mask while
working. Only work in well ventilated rooms or
outdoors.
6

Operation

6.1 General

- Personnel entrusted to work with the machine must
be made aware of these operating instructions,
calling particular attention to the chapter "Safety
instructions".
- Ensure that the cutter is fastened correctly.

6.2 Switching on and off

• Switching on: Slide the switch lock in the direction
of the arrow and press the switch button 8 (see Fig.
7)
• Switching off: Release switch button 8.
Fig. 7
As this is a switch without locking device, the machine
will only run while this switch button is pressed.
The built-in automatic brake limits the working tool's
slow-down time to approx. 1-2 s.
The machine is equipped with a restart protection. In
case of overload, you must first turn off the machine
and then turn it back on.

6.3 Work instructions

• Hold the gutter support inlet milling machine with
both hands, on hand at the additional handle and
the other hand on the motor casing.
• Switch on the machine.
• Place the base plate of the machine securely on the
flat area of the workpiece.
• Switch off the machine before removing one of your
hands from the machine or before lifting the
machine.
-26-