Scheppach HS720 Originalbetriebsanleitung Seite 89

• Perform a brake test prior to commencing work.
• To start up the saw, press the on/off switch.
• The saw is designed exclusively for cross-cutting
firewood with a maximum length of 1 metre.
• The smallest permissible wood diameter is 60 mm.
• With both hands on the handle, swivel the swivel
frame towards the saw blade.
• Then bring the swivel frame into the starting posi-
tion.
• The wood to be sawn must not be fixed by hand.
• After the saw has come to a complete standstill,
pull out the mains plug or close the fuel valve.
• Only carry out modifications, setting, measuring
and cleaning work when the engine is switched off.
Wait until the rotating tool has come to a standstill
and pull out the mains plug or close the fuel valve.
• On/off switch
Switching on
Press the green I button
Switching off
Press the red O button
Starting the engine, only valid for petrol variants
Follow the procedure below for cold starting:
1. Turn the fuel valve (B) to the right to the
open position.
2. Turn the choke lever (A) on the engine
fully to the left, to the "ON" position.
3. Set the throttle lever (C) to the half-open
position.
4. Turn the ignition switch (E) to ON.
5. Pull the recoil starter handle (D) slow-
ly several times so that the petrol flows
into the carburettor. Then hold the recoil
starter handle (D) and pull the cord out a
little until you feel resistance. Then pull
the cord out in one quick movement and
let the cord wind up again slowly. Do not
let the cord recoil. If necessary, pull the
recoil starter handle (D) several times
until the engine starts.
6. Let the engine warm up for a few seconds. Then gradually move the choke lever (A) to the right to the "OPEN" position.
Restarting an engine that is already warm from previous operation does not normally require the use of the choke.
1. Turn the fuel valve (B) to the right to the open position.
2. Set the throttle lever (C) to the half-open position.
3. Turn the ignition switch (E) to ON.
4. Then hold the recoil starter handle (D) and pull the cord out a little until you feel resistance. Then pull out the recoil
starter handle (D) in one quick movement and let the cord wind up again slowly. Do not allow the recoil starter handle
(D) to recoil.
After the engine has started, move the throttle lever (C) to the full throttle position so that the saw blade can reach its
maximum speed.
A
B
www.scheppach.com
C
D
E
GB | 29