Silvercrest SFB 80 A3 Bedienungsanleitung Seite 9

clean, non-slippery and
dry floor .
Never stand up with your feet
inside the product .
m WARNING! Do not use
this product and consult your
doctors if you suffer from any of
the following conditions:
Skin inflammations
–
Wounds/swelling of the feet
–
Skin reddening
–
Diabetes
–
Eczema/psoriasis
–
Heart disease
–
m CAUTION! The product's
surface becomes hot during
operation . Persons insensitive
to heat must be careful when
using the product .
m ATTENTION! Risk of
product damage! Do not
add any additives, like oil,
to the water container . After
the water has evaporated,
these additives may burn and
damage the product .
Fire/burn hazard and heat
m DANGER! Risk of fire!
Never leave the product
unattended while it is
plugged in .
Never select the keep warm
function if there is no water
inside the water container .
˜ Before first use
1 . Take the product out of the packaging
and remove all packaging materials and
plastic wrappings .
2 . Check to make sure that all listed parts are
included (see "Scope of delivery") .
3 . Check whether the product and all parts are
in good condition, if any damage or defect
is detected, do not use the product, but
follow the procedure described in chapter
"Warranty" .
4 . Before first use, clean all parts of the product
as described in the chapter "Cleaning and
care" .
˜ Preparation
m ATTENTION! Risk of product
damage!
Do not fill in water at a temperature
exceeding 42 ºC . Always check the water
temperature before placing your feet inside or
switching on the product .
Do not fill water above the
MAX marking
[ 9 ]
Do not splash water on the function
, the ON/OFF indication light
button
[ 1 ]
or the base of the product .
Do not remove the massage rollers
splash guard , except when cleaning the
2 ] [
product (see "Cleaning and care") .
NOTES:
Only use clean water . Do not add any soap,
o
bath salts or any other substances to the
water container
[ 8 ]
Do not operate the product without having
o
filled in water first .
Before and after each use: Clean the product
o
(see "Cleaning and care") .
1 . Fill the water container
with water in the desired temperature .
2 . Place the product on an even, stable, heat-
resistant, clean, non-slippery and dry floor .
3 . Connect the supply cord with power plug
to a suitable socket outlet .
.
10 ] [
or
15 ] [
.
up to MAX
8 ] [ 9 ] [
GB/IE/NI
19 ] [
9