laufen CLEANET PRO Bedienungsanleitung Seite 5

2 INTRODUCTION
SYMBOLS
2.1
Advice
SHOWER TOILET: INDICATOR LIGHT
2.2
The indicator light is located within the WC bowl. It provides information about required
maintenance or possible malfunctions on your shower toilet from inside (bowl light).
2.3 START UP
The remote control and the flush remote control control are linked at the factory. To start up
the product follow the steps described below:
1. Place the batteries inside both remote controls.
2. Open water supply valve.
3. Activate the power supply for the CLEANET SIT.
If the remote controls need to be linked again, follow the remote control linking process (see
section 2.5).
1
USE OF THE PRODUCT
2.4
When the product is first connected to the mains, it is necessary to wait at least 4 minutes to
be able to perform the first discharge of the toilet.
The CLEANET SIT has a small internal water tank that is cold in stand-by conditions.
When the user detector senses a seated user, the preheating process is activated.
The preheating takes place at 36ºC. The functions may be activated at any time, but if they
are activated too soon, the water will not have time to reach the established temperature;
therefore it is recommended a minimum preheating period of 30 seconds from the moment
the CLEANET SIT detects the user until any water function is activated.
When a function is activated, the CLEANET SIT carries out a cleaning of the nozzle before its
use.
When the function is finished and the user leaves the toilet, a subsequent cleaning process
of the nozzle takes place for 10 seconds.
Warning
2
5
3
ON