laufen CLEANET PRO Bedienungsanleitung Seite 16

6 CLEANING AND MAINTENANCE
6.1 CLEANING MODE
Cleaning mode (including nozzle extension) is activated by pressing rotary
button on remote + lady wash for 3 seconds, and the nozzle will be extended
for 5 minutes (and a green light turns on) and retract automatically or pressing
controller rotary button 5 seconds for exiting cleaning mode manually.
Do not use abrasive cleaning products. Only use neutral abrasive cleaning products.
Do not pull or push the nozzle manually.
It is forbidden to pull out nozzle by hand directly.
REMOTE CONTROL CLEANING
6.2
Please take out the batteries before cleaning.
Wipe it softly with a dampened cloth.
If the remote is too dirty, you may use diluted neutral
detergent to clean it.
It is forbidden to wash this product with water or detergent directly, or immerse in water.
6.3 REMOTE CONTROL BATTERY
If the LED flashes when any button is pressed it
is indicating the battery is low. Please replace the
battery.
The quantity of LED displays depends on the
current setting.
Please use AAA Alkaline battery. Do not mix the new
and used batteries nor different brands.
6.4 CLEANING BETWEEN THE CERAMIC AND
THE CLEANET SIT SURFACE
The product is fixed by a clip and some magnets.
It can be disassembled from the magnet fixation if
you pull up the device, but keep the clip bracket in
place in order to clean the ceramic surface under
the working parts of the smart toilet.
Doing that, it is possible to clean the toilet surface
under the e-bidet device.
Do not completely disassemble the equipment or turn it over.
Take care not to damage electrical components.
Do not use abrasive cleaners.
1
16
2 3 4