Werbung
Verfügbare Sprachen
Verfügbare Sprachen
20.3.1 WPS connection
This establishes a direct connection to the router. It is not necessary to select
and/or enter the WLAN network (SSID) and password.
>
Select [WPS setup] and press the OK button to start the
connection process.
>
Then start the WPS function on your router according to its operating
instructions.
20.3.2
Manual configuration
>
Select [Manual settings] and then [Wireless] to start the manual
configuration.
>
Now select whether you want your router to retrieve the IP address, gateway
etc. automatically (DHCP active) or enter them manually (DHCP inactive).
Please note that the automatic retrieval of the IP address, gateway and subnet
mask only works if the DHCP function is activated in your router.
>
Enter the IP address, subnet mask, gateway address, primary DNS and, if
necessary, secondary DNS one after the other using the arrow buttons on
the remote control. Confirm each set value with the OK button.
>
Now enter the name (SSID) of your WLAN network using the virtual
keyboard and confirm by selecting OK.
>
Select whether your WLAN network should be Open, WEP or WPA/WPA2.
is encrypted and confirm the following point.
>
Finally, enter your WLAN password using the virtual keyboard and
confirm by selecting OK to start the connection process.
As a rule, the WLAN connection can be used after a few seconds.
20.3.3
Show settings
>
Select [Show settings] to display the current network settings.
20.3.4
TechniSat Connect PIN
You can control the DIGITRADIO 760 CD IR with the TechniSat CONNECT app. To
do this, the PIN of the DIGITRADIO 760 CD IR must be entered in the app. You can
change the PIN here as follows.
>
Enter a 4-digit PIN under [NetRemote PIN Setup] and press the OK button to
save.
42
Werbung
