Product Use - Ferplast Risto Pet Smart Gebrauchsanweisung

READ AND FOLLOW THE INSTRUCTIONS IN THIS MANUAL CAREFULLY BEFORE USING THE
PRODUCT
• The device may only be used with the supplied adapter.
• Make sure that the voltage indicated on the transformer label corresponds to that of the mains supply.
• Before carrying out any maintenance work, be sure to disconnect the unit from the power supply.
• USB adapter power cables can neither be replaced nor repaired: if damaged, replace the entire component. The cable must never be cut.
• The device is intended for indoor use only.
• Ensure that your home is protected upstream by an earth leakage circuit breaker with a tripping current of no more than 30mA.
• Keep the cable of the appliance out of the reach of children under 8 years of age.
• This appliance may be used by children who are at least 8 years of age and by persons with reduced motor, sensory or cognitive capabilities or insufficient
experience and/or knowledge provided that they are supervised or have been instructed in the safe use of the appliance and are aware of the potential
dangers. Children must not be allowed to clean the appliance unless supervised by an adult. Children must not play with the appliance.
• This product is a cat or dog food dispenser, so do not use it in ways other than its original intended use.
• Be sure to position the power cable in such a way that your pet cannot bite or damage it.
• Please ensure that children do not eat from the dispenser. Do not put in any harmful substances or additives (e.g. scented oils) that could be accidental-
ly ingested by children or pets.
• DO NOT insert any foreign objects into the tank.
• Place the device on a flat, even surface. Monitor the device regularly.
• Do not install or store the device in locations exposed to sub-zero temperatures. Protect the device from direct sunlight.
• This device has been evaluated for use with dry dog and cat food only, with kibbles between 2 and 12 mm in diameter (larger kibbles may block the
dispenser). Do not use this device for other than its intended purpose (e.g. do not use with wet food, food for human consumption, etc.). The use of
accessories not recommended or sold by the device manufacturer may compromise safety.
• To avoid injury, do not touch moving parts and do not insert your fingers into the food outlet.
• Do not operate the device if the power cable, plug or battery is damaged, if it malfunctions, if it is dropped or if it is damaged in any way. If the power
cable or battery is damaged, it must be replaced by the manufacturer, its technical service department or similarly qualified persons in order to avoid any
risk. Never cut the cable.
• Never immerse the base in water as it may damage electronic components such as the control panel.
• Do not disassemble or modify the cooler other than as indicated in this manual
• Use only alkaline batteries type LR6 and check them regularly. Do not use rechargeable batteries.
• Switch off the device when not in use.
IMPORTANT - Within the European Union, a crossed-out wheelie bin symbol on the product, documentation or packaging indicates that the
product cannot be disposed of in the regular household waste stream, in compliance with EU Directive 2012/19/EC and with current local regu-
lations. The product must be disposed of at recycling centres or authorised waste disposal centres for electrical and electronic equipment, in
accordance with current legislation in the country where the product is found. Incorrect disposal of this type of waste can have a negative impact
on the environment and human health, caused by the potentially hazardous substances produce by electrical and electronic equipment. Correct disposal
of these products will also contribute to the efficient use of natural resources. Further information is available from the product retailer, the competent
local authorities and national manufacturer's organisations.
INSTALLATION
Take the unit out of its packaging and before using the feeder, clean it thoroughly with a dry or only slightly moistened cloth to remove any traces of dirt
or impurities. Read the complete cleaning instructions under Maintenance.
1 Open the lid (8) of the battery compartment (9) on the bottom of the main body and insert 4 LR6 Type AA batteries (not included) (A) so that the food
dispenser can operate automatically without external power. The backup battery is designed for a short-term alternative when the external power
supply is interrupted. When only the battery is present, the dispenser will go into sleep mode: Wi-Fi and all app operations will be unavailable. The
batteries will ensure the continuity of meal delivery at the programmed feeding time. WARNING: DO NOT use rechargeable batteries
2 Insert the USB cable (14), supplied, into the socket (10) on the base of the dispenser, pass it through the cable feed-through opening (12) and connect it
to the supplied 5Vdc - 1A - 5W USB power supply (15) (B) Make sure that the excess cable cannot be chewed or damaged by your pet.
3 Position the main body (4) on top of the bowl holder (7). Ensure that the main body fits correctly by lowering it vertically onto the bowl (C)Insert the
steel bowl into the bowl holder (D)
4 Place the food tank (2) on top of the main body of the dispenser (4), aligning it so that the small hooks on the front and back fit into the corresponding
slots on the base. Lock the tank by turning it clockwise (E) Ensure that the tank is level.
5 Fill the tank (2) with dry food, taking care not to overfill it (F)
6 Remove the desiccant sachet from its packaging and insert it into the compartment under the lid. Do not use the sachet if it is visibly damaged (G)
7 Put on the cover (1) and close it firmly using the spring-loaded button (H)
8 The dispenser is ready for use.

PRODUCT USE

Switching on
Install 4 x 1.5V LR6 batteries and connect the 5VDC 1A 5W power supply unit
Switchinf off
Remove the batteries and disconnect the power supply.
English 7