General Safety Notes; Functionality; Device Overview; Installation - Mohlenhoff Rlds 61071-N6 Einbauanleitung

Functionality

2.3

General safety notes

– Only use the device if it is in flawless state.
– Ensure that the device does not get into the hands of
children.
– Ensure that the device is not exposed to the effects of
moisture, vibration, constant sunlight or heat, cold or
mechanical stress.
– Only use the device within the power range and in the
ambient conditions specified in the technical data
Overloading can damage the device and cause a fire
or an electrical accident.
3 Functionality
The room control unit records the room temperature and air
humidity in the heating zone used and regulates these via a
base station for floor temperature control. The settings are
DE
made using the touch control buttons and the display. Room
and system-specific parameters are configured via the Alpha
EN
Smart app.
FR
In conjunction with a Premium base, the optional connection
set can also be used to realise additional functions such as
NL
dew point sensor, floor sensors and room sensors.
IT
ES
DA
5.1

Mounting with screws

NO
FI
SV
PL
EL
TR
10
Communication with the other participants takes place via
the cSP-L radio protocol. As the radio transmission is techni-
cally realised on a non-exclusive transmission path, interfer-
ence cannot be ruled out. Examples of interference are:
Switching operations, electric motors, defective electrical
appliances.

4 Device overview

see
A Room control unit
B Mounting base

5 Installation

see
1. Select a suitable mounting position
2. Ensure that no lines are laid at the installation position.
3. Detach the device from the mounting base using a suitable screwdriver
4. Align the mounting base horizontally on the wall
5. Mark two opposite drill holes using the mounting base
Wooden walls: Screw in screws directly, if necessary pre-drill with a
wood drill (1.5 mm)
Stone walls: Drill pre-marked holes with a 5 mm masonry drill bit,
insert dowels
6. Mount the mounting base using suitable screws
7. Place the device on the mounting base and snap it into the clamps
A
[page 2]
C Display with function indicators
D Touch control buttons
Changing the selection
System button:
Press briefly (< 1 sec) to confirm selection
Press and hold (> 3 sec) to execute the selected function
B
[page 2]