Scheppach RS400 Original Bedienungsanleitung Seite 22

- Up to three waste electrical devices per type of
device, with an edge length of no more than 25
centimetres, can be returned free of charge to
the manufacturer without prior purchase of a new
device from the manufacturer or taken to another
authorised collection point in your vicinity.
- Further supplementary take-back conditions of
the manufacturers and distributors can be ob-
tained from the respective customer service.
• If the manufacturer delivers a new electrical appli-
ance to a private household, the manufacturer can
arrange for the free collection of the old electrical
appliance upon request from the end user. Please
contact the manufacturer's customer service for
this.
• These statements only apply to devices installed
and sold in the countries of the European Union
and which are subject to the European Directive
2012/19/EU. In countries outside the European Un-
ion, different regulations may apply to the disposal
of waste electrical and electronic equipment.
16. Troubleshooting
The following table shows fault symptoms and describes remedial measures in the event of your machine failing to work
properly. If you cannot localise and rectify the problem with this, please contact your service workshop.
Fault
Motor does not run
Motor running but screen
drum does not turn
Screening material is not fully
screened
22 | GB
Possible causes
Connection cable defective
Switch defective
Motor belt defective or tension too
low
Screen drum belt defective or ten-
sion too low
Screening material clumping and/or
too moist
Screen drum angle too steep
www.scheppach.com
Action
Check connection cable and replace if neces-
sary
Arrange for inspection and repair of the device
by a specialist
Check motor belt, tension or replace
Check screen drum belt, tension or replace
Crush the screening material first and/or wait un-
til the screening material is drier.
Reduce the angle of the screen drum