16. Troubleshooting
The following table shows fault symptoms and describes remedial measures in the event of your machine failing to work
properly. If you cannot localise and rectify the problem with this, please contact your service workshop.
Fault
Possible cause
E1
Coil Sensor-Error
E2
Moisture Sensor-Error
E3
Temperature Sensor-Error
E4
Hot and Cold System-Error
E5
Room Temperature too high
ERROR
Dehumidifier does not work.
Bad Dehumidification Perfor-
mance
High Noise Level
Water flows out of the device
Remedy
Exchange the coil sensor.
Exchange the moisture sensor.
Exchange the temperature sensor.
Have the dehumidifier checked /repaired by a specialist.
Lower the room temperature and
dehumidifier will restart automatically.
ERROR
•
Device has no power.
•
Mains plug is not plugged in prop-
erly.
•
Display shows error code FU.
•
Air in- or outlet is covered.
•
Room is not closed.
•
Low moisture and temperature.
•
Device was not put on even ground.
•
Air in- or outlet is covered.
Leakage of the water collecting contain-
er.
www.scheppach.com
SOLUTION
•
Turn on the power supply.
•
Connect the mains plug properly.
•
•
Empty the water collection container.
•
Uncover Air in- and outlet.
•
Close all doors and windows.
•
The lower the room temperature the
worse the dehumidification perfor-
mance.
•
Position the device on even ground.
•
Uncover Air in- and outlet..
•
Check the water collecting container.
•
Replace the water collecting con-
tainer.
GB | 29