Herunterladen Diese Seite drucken

Scheppach BTR6500 Originalbetriebsanleitung Seite 21

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

1. Introduction
Manufacturer:
Scheppach GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear Customer,
We hope your new device brings you much enjoy-
ment and success.
Note:
In accordance with the applicable product liability
laws, the manufacturer of this device assumes no
liability for damage to the device or caused by the
device arising from:
• Improper handling,
• Failure to comply with the operating instructions,
• Repairs carried out by third parties, unauthorised
specialists,
• Installing and replacing non-original spare parts,
• Application other than specified,
• Failures of the electrical system in the event of the
electrical regulations and VDE provisions 0100,
DIN 57113 / VDE0113 not being observed.
Note:
The operating manual is part of this product.
It includes important instructions for the safe, proper
and economic operation of the product, for avoiding
danger, for minimising repair costs and downtimes
and for increasing the reliability and extending the
service life of the product.
In addition to the safety instructions in this operating
manual, you must also observe the regulations appli-
cable to the operation of the product in your country.
Familiarise yourself with all operating and safety in-
structions before using the product. Only operate the
product as described and for the specified areas of
application.
Keep the operating manual in a good place and hand
over all documents when passing the product on to
third parties.
2. Device description (fig. 1-5)
1. Handle
1a. Support foot (left)
1b. Support foot (right)
1c. M6x10 mm Phillips screw
2. Wheels
2a. Wheel axle
2b. Safety splints
2c. Hexagonal bolts
3. Housing door
4. Air inlet
5. LCD display
6. Drain hose
6a. Hose clamp
7. Water tank
7a. Plug
LCD display
A. Dehumidification mode
B. Level indicator
C. Automatic defrosting
D. Speed display
E. Operating hours counter
F. Adjust speed
G. Reduce target humidity
H. Increase target humidity
I. On/off switch
J. Ambient humidity display
3. Scope of delivery
Quantity
1x
1x
2x
2x
2x
2x
8x
1x
1x
1x
1x
4. Intended use
The device is intended for 230 V AC voltage devices.
The construction dryer is only suitable for indoor use,
for drying damp walls, after water damage or for redu-
cing the humidity in closed rooms larger than 10.1 m².
The product may only be used in the intended man-
ner. Any use beyond this is improper. The user/opera-
tor, not the manufacturer, is responsible for damages
or injuries of any type resulting from this.
An element of the intended use is also the observan-
ce of the safety instructions, as well as the assembly
instructions and operating information in the opera-
ting manual.
Persons who operate and maintain the product must
be familiar with the manual and must be informed ab-
out potential dangers.
The liability of the manufacturer and resulting dama-
ges are excluded in the event of modifications of the
product.
www.scheppach.com
Designation
Wheel axle
Handle
Wheels
Hexagonal bolts
Split pins
Support feet
M6x10 mm Phillips screw
Drain hose
Hose clamp
Water tank
Operating manual
GB | 21

Werbung

loading

Diese Anleitung auch für:

5906504901