Bosch AdvancedMulti 18 Originalbetriebsanleitung Seite 20

20 | English
LED
2 × continuous green light
1 × continuous green light
1 × slowly flashing green light
If the battery charge indicator on the power tool flashes red,
the power tool is overloaded.
Battery Charge Indicator on the Rechargeable
Battery
Note: Not all battery types have a battery charge indicator.
The LEDs on the battery charge indicator on the re-
chargeable battery indicate the state of charge of the bat-
tery. For safety reasons, it is only possible to check the char-
ging status when the power tool is at a standstill.
Press the button for the battery charge indicator on the re-
chargeable battery to show the state of charge. This is also
possible when the rechargeable battery is removed.
LEDs on rechargeable battery
4 × continuous green light
3 × continuous green light
2 × continuous green light
1 × continuous green light
1 × flashing green light
Recommendations for Optimal Handling of the
Battery
Protect the battery against moisture and water.
The following table shows examples of accessories. You can find additional accessories in Bosch's extensive range of ac-
cessories.
Accessory
Bi-metal segment
saw blade
Sanding plate for
Delta series 93 mm
sanding sheets
1 609 92A B1B | (19.12.2024)
Only store the battery within a temperature range of −20 to
State of charge
50 °C. Do not leave the battery in your car in the summer, for
≈ 40–75 %
example.
≈ 15–40 %
A significantly reduced operating time after charging indic-
≈ 0–15 %
ates that the battery has deteriorated and must be replaced.
Follow the instructions on correct disposal.
Assembly
Before carrying out any work on the power tool (e.g.
u
maintenance, tool change etc.), remove the battery
from the power tool. There is risk of injury from uninten-
tionally pressing the on/off switch.
Changing the Accessory
Wear protective gloves when changing accessories.
u
There is a risk of injury when touching the accessories.
Selecting an Accessory
Please observe the accessories intended for your power
State of charge
tool.
≈ 75–100 %
≈ 50–75 %
Accessory
≈ 25–50 %
≈ 5–25 %
≈ 0–5 %
Material Application
Wood-based materials, Separating cuts and plunge saw cuts;
plastic, non-ferrous including sawing close to edges, in corners and in difficult-
metals to-reach areas.
Example: Shortening door frames or skirting boards that
are already installed, plunge cuts when adapting floor pan-
els
Depends on the sanding Sanding surfaces at edges, in corners or in difficult-to-
sheet reach areas;
depending on the sanding sheet, e.g. for sanding wood,
paint, varnish, stone;
fleeces for cleaning and for texturing wood, removing rust
from metal and for keying varnish, polishing felt for pre-
polishing
Oscillation speed rate level "4" is the maximum level that
should be used when sanding. If the oscillation speed rate
is too high, this will considerably increase the wear on the
accessory and can also lead to premature breakdown.
AdvancedMulti 18
Bosch Power Tools