cecotec CONGA POOLDROID 2000 FLOORMASTER Bedienungsanleitung Seite 73

- Use a tissue to remove any debris stuck to the wheels.
3. Reassembling the robot Fig. 13
Start by fitting parts 4 and 3 first (pay attention to the alignment of part 3 during installation).
When fitting part 1, first pry open part 2. Attach the front and rear latches first, then the side
ones.
5. TROUBLESHOOTING
Problem
The robot does
switch on.
The indicator lights do
not come on.
The robot stays on the
edge of the pool and
stops cleaning.
The robot is running but
does not move.
Other
6. TECHNICAL SPECIFICATIONS
Product reference: EU01_107959
Product: Conga Pooldroid 2000 FloorMaster
Voltage: 100-240 V ~
Frequency: 50/60 Hz
Rated power: 30 W
Battery: 12 V ⎓ 5000 mAh, 60 Wh
Rated charger output: 13.5 V ⎓ 1.8 A
Technical specifications may change without prior notification to improve product quality.
Made in China | Designed in Spain
Cause
not Battery level is low.
The wheels are stuck.
The wheels are damaged.
Solution
Charge the robot.
Clean the wheels.
Contact the
Technical Support Service.
Contact the
Technical Support Service.
CONGA POOLDROID 2000 FLOORMASTER
ENGLISH
official Cecotec
official Cecotec
73