cecotec CONGA POOLDROID 2000 FLOORMASTER Bedienungsanleitung Seite 70

ENGLISH
3. OPERATION
Operation indicator lights
- If the battery is fully charged, the blue indicator light will remain steadily on.
- Before the robot comes into contact with the water, an acoustic signal will sound. When
the robot has come into contact with the water, the acoustic signal will stop sounding.
- The robot will automatically turn off if it is not placed in water within 60 seconds after it
has been switched on.
Battery level indicator light during charging
- If the battery level is below 30%, the red indicator light will flash.
- If the battery level is between 30% and 99%, the blue indicator light will flash.
- If the battery level is at 100%, the blue indicator light will remain steadily on.
Switching the pool cleaner robot on/off
Figure 2 shows the bottom side of the robot pool cleaner, where the charging port and the
power button are located. To switch on the robot, press and hold the power button for 2
seconds. To switch off the robot, repeat this procedure.
Fig. 2 key:
1. Charging port
2. Power button
Self-test function
The red and blue indicator lights will flash alternately. Press and hold the power button for 2
seconds, a beep will sound and the red indicator light will be illuminated, indicating that the
self-test is in progress.
Start-up
The blue indicator light will flash rapidly twice per second and a beep will sound.
Water detection
The robot will automatically turn off if it is not placed in water within 60 seconds after it has
been switched on.
Pool entry process
- Before placing the robot in the water, make sure that there is no air inside the robot. Figure
3 shows the correct way to put the robot into the pool. Figure 4 shows the incorrect way
to put the robot into the pool.
- After entering the water, it will take about 20 seconds for the robot's mechanism to start
up and allow the robot to sink gently to the bottom of the pool.
70
CONGA POOLDROID 2000 FLOORMASTER