cecotec CONGA POOLDROID 2000 FLOORMASTER Bedienungsanleitung Seite 71

Automatic reverse function
If the robot bumps into any wall of the pool, it will reverse.
Automatic speed setting
The robot automatically adjusts its speed according to the surface it is standing on.
Autoparking system
When the robot's battery level is low, the robot will move to the nearest pool edge. At this time,
the red and blue indicator lights will flash alternately once per second and a beep will sound.
If the battery level is too low, the robot will automatically switch off. This prevents the battery
from being completely discharged, thus extending its lifespan.
Fitting the brush
Position the brush as shown in figure 5.
Fixing the upper housing
Make sure that the upper housing is correctly fitted to the robot body. Fig. 6
To attach the upper housing to the robot body, align the latches as indicated by the arrows and
ensure that they fit correctly. Once the housing is fully fixed, you will hear a click. Fig. 7
Removing the robot from the pool
Before picking up the robot, place it on the surface of the water for 10-15 seconds until it is
completely empty, then remove it from the pool.
Operation
Charging the robot
Use the charger supplied to charge the robot.
- Before charging, make sure that the charging port is clean.
- The battery indicator light will flash during charging.
- When the battery level is at 100%, the blue indicator light will remain steadily on.
Switching on the robot
To switch on the robot, press and hold the power button for about 2-3 seconds. Once the robot
is switched on, the corresponding indicator light will flash and an acoustic signal will sound.
Placing the robot in the pool
Then place the robot in the pool within 60 seconds (otherwise it will switch off automatically).
Release the air from inside the robot and allow it to sink to the bottom of the pool within 20
seconds.
CONGA POOLDROID 2000 FLOORMASTER
ENGLISH
71