Technical Data; Installation - Electrolux EUC05002W Benutzerinformation

8 electrolux
Problem
It is too cold inside the
freezer
The appliance does not
work at all.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to

"Installation".

TECHNICAL DATA

Dimension
Rising Time
Voltage
Frequency
The technical information are situated in the
rating plate on the internal left side of the
appliance and in the energy label.
INSTALLATION
Read the "Safety Information" carefully
for your safety and correct operation of
the appliance before installing the
appliance.
Positioning
This appliance can be installed in a dry, well
ventilated indoor (garage or cellar) also, but
for optimum performance install this appli-
ance at a location where the ambient tem-
perature corresponds to the climate class
indicated on the rating plate of the appli-
ance:
Possible cause
Temperature regulator may be
set incorrectly
Plug is not connected to the
mains socket properly
Power does not reach the appli-
ance
The appliance is not switched
on
There is no voltage in the mains
socket (try to connect another
appliance into it)
Plug is not connected to the
mains socket properly
Height
Width
Depth
Set a warmer temperature
Connect the mains plug properly
Try connecting another electrical
device to the power outlet
Switch on the appliance
Call an electrician
Connect the mains plug properly
3. If necessary, replace the defective door
gaskets. Contact the Service Center.
520 mm
525 mm
587 mm
17 h
230 V
50 Hz
Climate Ambient temperature
class
SN +10°C to + 32°C
N +16°C to + 32°C
ST +16°C to + 38°C
T +16°C to + 43°C
Rear spacers
In the bag with the documentation, there
are two spacers which must be fitted as
shown in the figure.
Using fine strokes of hammer put them in
their place.
Solution