Denver NEC 275 RM Benutzerhandbuch Seite 90

ERROR CODE DEFINITION
Error code
The accelerator is
not not in place
"05"
System over voltage
"07"
The Hall signal in the
"08"
motor is abnormal
Phase wire in motor
"09"
Motor overheat
( occurs uniquely
"10"
when the engine is
temperature sensor .
Engine temperature
sensor abnormal (
occurs uniquely
"11"
when the engine is
equipped with the
temperature sensor .
Controller current
" 12"
sensor abnormal
"14"
overheating
Cause
1. Check if the accelerator is in place .
2. Check if the cable accelerator is properly connected or if
the cable (from throttle to controller ) is damaged .
3. Troubleshoot the room defective :
1) Replace the accelerator
2) Replace the controller
1. Check if the nominal voltage of the battery is the same as
that of the controller .
2. Troubleshoot the defective part :
protection
1) Replace the battery
2) Replace the controller
1. Check if the motor cable is properly connected Or if the
cable (from the motor to the controller ) is damaged .
2. Troubleshoot the defective part :
1) Replace the motor
2) Replace the controller
1. If you ride for a long time , turn off the system and let the
engine cool .
2. If you do not ride or ride for a short period , troubleshoot
abnormal
the faulty part :
1) Replace the motor
2) Replace the controller
1. If you roll during a long time , turn off the system and let
protection
the engine cool .
2. If you don't ride not or don't ride not during a short period
, troubleshoot the part defective :
crew of one
1) Replace the motor
2) Replace the controller
)
1. Check if the motor cable is properly connected or if the
cable (from the motor to the controller) is damaged .
2. Troubleshoot the defective part:
1) Replace the motor
2) Replace the controller
)
Replace Controller
Controller
1. If you ride for a long time , turn off the system and let the
controller cool .
protection
Hubmotor System
90