Denver NEC 275 RM Benutzerhandbuch Seite 81

•
Do not touch the disc brakes after intensive use of the braking system of your
electric bike at the risk of being burned.
Adjusting the hydraulic disc brakes
The brake pads exert pressure on a disc fixed in the hub of the wheel. The intensity of the pressure is
regulated by a brake lever with a liquid via the pressure exerted via the water hose. Do not apply the
brake lever when the wheel is detached from the frame or the fork.
To align the automatic disc brake bracket, unscrew the bracket fixing screw from the brake bracket. Brake
with the corresponding brake lever (the brake bracket is correctly positioned) and hold the brake handle
in this position by tightening the fixing screws of the bracket bracket.
Check that the inner pad (inside the wheel) is 0.2 - 0.4mm from the disc. If this is not the case and you are
not comfortable with this operation, contact a qualified technician. It is recommended that you never
pour oil or lubricating material on the disc or pads (when servicing the chain or derailleur, for example).
If this happens, the pads or rotor should be degreased or replaced. Check the alignment of the pads by
spinning the wheel to use the bike on the road. Disc: the bike is equipped with discs with a diameter of
160 mm.
brake pads are standard, replace them when the pad no longer has any friction elements.
Don't forget not only new brake pads must be lapped . Breaking -in is done by using the bike for a few
minutes and applying the alternating brakes between stops abrupt and light braking .
Replacement of brake pads
Remove the wheel and remove thr old brake caliper pads. Place the pads new In the stirrup so that that
the braking surfaces are touching . Don't touch not the braking surfaces. Insert the pads one by one In the
brake caliper.
Wheel wear
As all piece wear, the rim must be controlled regularly. The hoop can weaken and break, you doing lose
control or fall.
81