Temperature Setting; Maintenance - Dometic C-Serie Gebrauchsanweisung

teMperature setting

Plug in the wine cellar and turn it on with the
switch.
The wine cellar is equipped with an electronic reg-
ulator. This allows you to programme the tempera-
ture inside the wine cellar. Your wine will then be
stored between 10°C and 15°C according to expert
advice. The temperature is shown on the display.
The temperature, pre-set at 12°C, can be changed
according to the wine stored.
1. Press and hold the UP
arrow button for a few seconds until the
display starts blinking.
2. Release the button. Press the UP/DOWN
arrow buttons to set the temperature.
The new value is saved automatically after
6 seconds.
It is important to avoid rapid temperature
changes inside your wine cellar!
( )
( ▲ )
or DOWN
▼
-  -

Maintenance

We recommend that you keep your wine cellar as
clean as possible. Unplug the cellar before clean-
ing. Do not use any abrasive or strong scented
substances. Use a smooth cloth or sponge and light
detergent.
It is very important to check regularly that the air
circulation underneath and behind the cellar is
not blocked. Condensation collects in a small cup
placed at the back of the wine cellar. The cup has a
sponge which helps the condensation to evaporate.
Check that the plastic pipe routing the water from
the inside to the cup is not blocked by dust or dirt.
You should replace the inside ventilation charcoal
filter every second year. The filter is fitted in the
upper left corner inside the wine cellar.
If the wine cellar fails to work, check the following
points before calling a service technician:
• Is the fuse of power supply intact?
• Is the plug properly inserted in its socket?
• Is the wine cellar switched on?
If the cause of failure is not to be found among the
points listed above, contact an authorised service
technician.
The wine cellar is equipped with an overheating
protection. An authorised service technician can
check whether this has been triggered or not.