ChiQ CID282NEIBE Bedienungsanleitung Seite 6

Unobstructed ventilation shall be maintained around the appliance or in an embedded structure.
Preparations for use
1.
Standing time
After the refrigerator is properly installed and well cleaned, do not switch it on immediately. Make sure to energize the
refrigerator after more than 1 hour of standing, to ensure its normal operation.
2.
Cleaning
Confirm the accessory parts inside the refrigerator and wipe the inside with a soft cloth.
3.
Power-on
Insert the plug into the solid socket to start the compressor. After 1 hour, open the freezer door, if the temperature inside
the freezer compartment drops obviously, it indicates the refrigeration system is working normally.
4.
Storage of food
After the refrigerator runs for a period of time, the internal temperature of the refrigerator will be automatically controlled
according to the user's temperature setting. After the refrigerator is fully cooled, put in foods, which usually need 2~3
hours to be fully cooled. In summer, when the temperature is high, it takes more than 4 hours for the foods to be fully
cooled (Try to open the refrigerator door as less as possible before the internal temperature cools down).
If the refrigerator is installed in the moisture place, make sure to check whether the ground wire and leakage circuit
breaker are normal. If vibration noises are produced due to the refrigerator contacting the wall or if the wall gets blackened
by air convection around the compressor, move the refrigerator away from the wall. Setting up the refrigerator may cause
jamming noise or image chaos to the mobile phone, fixed-line telephone, radio receiver, television set surrounding it, so
try to keep the refrigerator as far away as possible in such case.
Functions
The display panel is designed on the fridge door, illustrated as the figures below:
Function Setting
When the refrigerator system is connected to power supply for the first time, all icons on the
display panel gets illuminated for 2s. When the refrigerator door is close, the display gets
extinguished automatically if no key operation within 3 minutes. When the display is off, it will
light up if refrigerator door is opened or any key is pressed.
The following key operations are valid only when the keys are unlocked and gets illuminated
on the display.
1.Functions
1.1Temperature setting
Press the "Temp" key to adjust the temperature to the expected temperature value, and if
no key operation within 5s, the setting will take effect, with the system running according
to the setting immediately.
The temperature setting cycles as following:
"5-4-2-8-6-5".
1.2 Fast cooling
1）When the fast cooling function is enabled, the fridge temperature cools down quickly, so
does the freezer temperature, ensuring that the storge foods have fresh taste and
maintain nutritious. The fast-cooling function keeps working for at most 30 hours,
beyond which it will exit automatically, with the temperature mode restored to that that is
set before the fast-cooling function is enabled.
2）To enter the fast cooling function
Press the "Mode" key until the fast-cooling icon starts flickering, and if no key
operation within 5s, the setting will take effect, with the said icon normally On.
3）To exit the fast-cooling function
 After a cumulative running period of 30 hours, the fast-cooling function will exit
automatically.
When the fast-cooling function is active, press the "Mode" key until theicon of

smart function gets flickering, and if no key operation within 5s, the smart function
will be enabled, with the fast-cooling function disabled.
When the fast-cooling function is active, press the "TEMP" key to adjust the

temperature to the expected mode, and if no key operation within 5s, the setting
will take effect, with the temperature controlled accordingly and the fast-cooling
function exited.
EN