Inhaltsverzeichnis
Werbung
Connection Diagram
guitar
headphones
effect device
Pin Assignment of the DSP (14) Jack
(View from outside onto the jack)
20
front
back
output input
foot switch
foot switch
DSP
CH SELECT
Connecting the Device to the Power Source
Connect the power cable supplied to the
power connector (11, female) and the
power plug to a shockproof socket.
The POWER switch (9) is used to switch
the guitar amplifier on and off.
Operation
Turn the CLEAN VOLUME (2), LEAD
GAIN (4) and LEAD VOLUME (5) to the
minimum setting (left stop).
If required, switch on the pick-up of the
guitar.
Switch on the guitar amplifier with the
POWER (9) switch.
Play your guitar and adjust the CLEAN
and LEAD channels.
You can switch between the two chan-
nels using the CH.SEL switch (3) or the
footswitch connected to the CH SEL-
ECT jack (14).
The sound is adjusted using the EQUA-
LIZATION (6) controls.
Use the DSP keys (8) to adjust the inte-
grated digital signal processor.
The effects are adjusted via the EFFEC-
TS LEVEL control (7).
When the device is switched on, the
power indicator in the power switch
lights up.
CLEAN VOLUME (2):
Volume of the CLEAN channel.
LEAD GAIN (4):
Distortion rate of the LEAD channel.
LEAD VOLUME (5):
Volume of the LEAD channel.
TREBLE = treble range
MIDDLE = middle range
BASS = bass range
PRESENCE = presence range
The operation is described below:
21
Werbung
Inhaltsverzeichnis
