cecotec BEERFLOW STEEL 5000 Bedienungsanleitung Seite 54

ENGLISH
2. Thin metal rod
Fig. 29 key:
1. Connecting cylinder
2. Connector sealing ring
3. Empty cylinder
Beer tube replacement
In the event of a break in the beer tube, leakage is possible. If this happens, replace it with a
new one.
To do so, follow the indications below (Fig. 30):
1. Lift the tap housing carefully and remove it. Then, pull the handle down to open the tap and
disconnect the beer tube.
2. Remove the tube clamp and remove the quick coupling.
3. Replace the beer tube with a new one following the same procedure, but in reverse order.
Note: the beer tube must be replaced with an identical one, otherwise leakage may occur.
Fig. 30 key:
1. Remove the top cover of the tap and the switch button.
2. Clamp
3. Quick coupling
Replacement of the suction tube seal
If a leak is detected in the suction tube, the seal must be replaced. To do that:
1. Remove the suction tube by unscrewing it counterclockwise.
2. Remove the worn seal, fit a new one and reattach the suction tube to the connector by
turning it clockwise.
Fig. 31 key:
1. Beer suction tube sealing ring
2. Beer suction tube
6. TROUBLESHOOTING
Some problems are due to lack of regular maintenance or neglect, which can easily be solved
without calling a technician.
To save time and money, if the beer dispenser stops working properly, before contacting the
official Cecotec Technical Support Service, check the table below and see if you can solve the
problem yourself.
54
BEERFLOW STEEL 5000