Werbung
Verfügbare Sprachen
Verfügbare Sprachen
OPERATION
@ RADIO OPERATION
Manual and Automatic Seek Tuning
The radio does not operate in the tape play mode.
To listen to the radio, eject the
cassette by pressing the EJECT switch ®.
Pressing the EJECT switch @ during tape play causes the tape in the loading slot to be
ejected.
1. Turn on the power by turning the VOLume control/Power switch @ clockwise.
Continue to rotate it unti! the desired volume level is reached.
2.
Push the BAND select switch @ for reception of MW, LW or FM (FM 1 or FM2). The
radio Band Indicator
© will be on, and the ST [stereo] indicator @ will also be on
during FM stereo reception.
3. Adjust the BASS ©, TREBle @, BALance @, and FADer @ controls to suit your
listening preference.
4. To automatically tune, press the TUNE switch @ and then either UP @ or DN @ tuning
switch. The SEEK indicator @ appears on the display and the frequency changes to
indicate that the radio is in the auto SEEK tuning mode and ready to stop at every
strong station. Repeat the procedure until your desired station is obtained. When the
radio reaches the upper or lower end of the band, it automatically starts scanning in
the opposite direction. To return to manual tuning, press the TUNE switch again, the
SEEK indicator disappears.
5. To manually tune, press the Tuning Switch (UP) @ for higher frequency broadcasts,
and press the Tuning switch (DN) @ for lower frequency broadcasts.
6. To switch from FM to MW/LW or vice versa, press the BAND select switch @.
Manual Memory Preset
Follow the instructions below to memorize stations for preset tuning.
1. Select the tuning band (FM1, FM2, MW or LW) © with the BAND select switch @.
2. Tune in your desired station by manual tuning or Auto SEEK tuning.
3.
Press any Preset switch (8 for more than two seconds.
The Address indicator @ in
the display will begin to blink. Press that switch a second time while the indicator is
blinking for five seconds.
4. The preset number will be memorized and will then show in the display @.
Note:
If a preset memory has already been set in the same address, it will be
cleared and the new station will be memorized.
Auto MEMOry Preset
1.
Press the TUNE switch @® and light up the Auto MEMO indicator @.
2.
Select the desired tuning band (FM1, FM2, MW or LW) © with the BAND switch @.
3. Press the tuning UP @ or DN @ switch.
It will automatically seek 6 strong stations in each band and memory the stations in
order of the signal strength from the strongest station for the Address No. 1 to the 6th
strong station for the Address No. 6. When the station is memorized, the address
indicator (No. 1 — 6) @ will appear.
First, it seeks the stations in the local tuning. If
the stations memorized are less than 6, it seeks the stations in the distance (DX)
tuning.
13
Werbung
